|
2723
ACRYLIC PLASTER
Formerly While stocks last. Replaced by 2727.
Ready-to-use finishing plaster for granular textured look
Crack-resistant and water-repellent for long lasting protection
- Highly flexible: Reduces cracking by compensating thermal and structural stresses.
- Polymer-based for low water absorption: Keeps walls dry.
- Ready made in a bucket: Easy to apply and texture.
- Available in a wide range of colors and textures on demand.
- UV-stable: For a durable finish.
Area of application
- Outdoors: wall + ceiling
- Indoor: wall + ceiling
Processing method
- For hand and machine processing
- Final surface treatment for insulated and non-insulated surfaces such as ETICS, mineral, and concrete on both new and historic buildings.
- Suitable for indoor and outdoor use as a decorative plaster.
Processing details
Learn more about technical details for processing this product.
Substrate requirement
The substrate must comply with the applicable standards, must be solid, free of loose particles, free of dust, paint, residues of demoulding agents and efflorescence. It must be sufficiently rough, dry, evenly absorbent and matured. The surface must not be frozen or water repellent. The substrate must be stable in volume.
Substrate preparation
Depending on the substrate’s water absorption and climatic conditions, apply CEMIX 2614 DEEP PRIMER on highly absorbent substrates, followed by a CEMIX 2613 BASIC PRIMER for pasty plasters. For smooth substrates, roughen the surface or apply a Cemix contact bridge to improve adhesion. Non-standard substrates must be treated with appropriate methods to achieve the required properties. Any unevenness should be smoothed using suitable Cemix materials and allowed to dry and cure completely.
The substrate shall comply with applicable codes, standards, or material manufacturer's recommendations.
Preparation of the mixture
Mix the CEMIX 2723 ACRYL PLASTER thoroughly before application using a slow-speed mixer with a suitable attachment. The consistency of the plaster can be adjusted depending on application conditions and shade saturation by adding a maximum of 1% clean water.
Mixing
Mixing time
2 min
Mixing speed in Rpm
800x/min
Processing instructions
Apply the plaster evenly to the surface using a stainless steel trowel or another suitable tool. Smooth it down to match the grain size.
For a scratch-textured finish, create the desired pattern using circular movements. For grooved textures, structure the surface in the direction of the intended grooves. Clean the trowel regularly during application to maintain a consistent finish.
When using a machine, spray the plaster evenly in one layer using a suitable spray gun. No additional smoothing is required after application.
Application thickness
| Minimum layer thickness | 1.5 mm |
|---|---|
| Recommended layer thickness | 2 mm |
| Maximum layer thickness | 3 mm |
Consumption
Material consumption min.
2.5
Material consumption max.
3
Material consumption in measuring unit
Kg/m²/layer
Treatment after application
After application, protect the surface from direct sunlight, heat, high humidity, and draughts. Protect from frost and rain. Do not apply direct heat to accelerate drying.
Tool and cleaning instructions
Wash off tools with water immediately after finishing work. Clean dried residues mechanically.
References
Technical parameters
| Main binder | Polymer dispersion |
| Made of material | Mineral binders, polymer dispersions, improvers and protective agents in microcapsules. |
| Liquid water permeability | W2 |
| Permeability water vapour air | V2 |
| Thermal conductivity λ in W/(m.K) | 0.65 |
| Water vapour diffusion resistance factor µ | 204 |
Files
|
|