|
8103
AQUASTOP CORNER IN
Formerly Flexible sealing tape inner corner
Reinforced internal corner seal
Eliminates the common cause of leaks in pools and all wet areas
- Flexibility: for maintaining high elasticity and resisting cracks even in extreme freezing conditions
- Deep-water protection: built to withstand extreme water pressure up to 50m (5 bar)
- Advanced chemical resistance: highly resistant to degradation from chlorine, salt water, and common pool chemicals
- Enhanced textile bond: ensures a permanent, leak-proof connection where different building materials meet.
Area of application
- Outdoor: floor + wall
- Indoor: floor + wall
- For swimming pool
Heating and cooling area
- Floor + Wall
Processing method
- For hand processing
- For flexible connection of structures when waterproofing layers are applied. For making expansion joints in waterproofing screeds. For balconies, swimming pools, spas and bathrooms. For dispersion, polymer cement and bitumen waterproofing screeds.
Contact
Loading...
Processing details
Learn more about technical details for processing this product.
Substrate requirement
The substrate must comply with the applicable standards, must be solid, free of loose particles, free of dust, paint, residues of demoulding agents and efflorescence. It must be sufficiently rough, dry and evenly absorbent. The surface shall not be frozen or water-repellent. The substrate must be stable in volume.
Substrate preparation
Depending on substrate water absorption and climatic conditions, the following is needed: Use Cemix 2614 primer on absorbent substrates, roughen smooth substrates or use Cemix 8040 contact bridge. For non-standard substrates, modify with a suitable method to achieve the desired properties. Smooth unevenness of substrate with suitable Cemix materials and allow to dry and cure. The substrate shall comply with applicable codes, standards, or material manufacturer's recommendations.
Processing instructions
Apply a thin layer of waterproofing compound to the previously prepared substrate using a suitable tool, e.g. a brush, and immediately apply the corner. Press in and smooth. Overlap the tape by 10-15 cm. When applying the second layer of waterproofing compound, cover the tape with this compound. Push in so as not to damage the corner - do not use sharp tools.
Temperature resistance: -30 °C to +90 °C
Tensile strength: 190%
Watertightness: 0.5bar
Consumption
Material consumption min.
1
Material consumption max.
-
Material consumption in measuring unit
Treatment after application
After application, the direct negative effects of sun, heat, humidity and draughts should be avoided. Protect from frost and rain. Direct heating of the surface is prohibited.
Technical parameters
| Made of material | Based on synthetic caoutchouc with non-woven fabric. |
Files
|
|