|
8100
AQUASTOP TAPE
Formerly Flexible sealing tape
Flexible connection and reliable sealing
The unbreakable seal for floor-to-wall joints and expansion gaps
- Flexibility: for maintaining high elasticity and resisting cracks even in extreme freezing conditions
- Deep-water protection: built to withstand extreme water pressure up to 50m (5 bar)
- 120mm wide shield: provides wide coverage and reliable reinforcement for structural joints and perimeters
- Advanced chemical resistance: highly resistant to degradation from chlorine, salt water, and common pool chemicals
- Enhanced textile bond: ensures a permanent, leak-proof connection where different building materials meet.
Area of application
- Outdoor: floor + wall
- Indoor: floor + wall
- For swimming pool
Heating and cooling area
- Floor + Wall
Processing method
- For hand processing
- For creating elastic seals during the application of waterproofing layers. Designed for reinforcing expansion joints within waterproofing systems. Suitable for balconies, swimming pools, SPA zones, and bathrooms. Compatible with dispersion-based, polymer-cement, and bitumen-based waterproofing compounds.
RECOMMENDED SYSTEM PRODUCTS
Contact
Loading...
Processing details
Learn more about technical details for processing this product.
Substrate requirement
The substrate must comply with the applicable standards, must be solid, free of loose particles, free of dust, paint, residues of demoulding agents and efflorescence. It must be sufficiently rough, dry and evenly absorbent. The surface shall not be frozen or water-repellent. The substrate must be stable in volume.
The substrate must not contain active (developing) cracks.
The tape must adhere over its entire surface without voids.
No cavities, blowholes, sharp protrusions, or uneven transitions are allowed.
The surface must be cleaned from the weak bonding layer formed after casting/plastering.
Substrate preparation
Depending on the absorbency of the substrate and climatic conditions, the following is required: apply Cemix 2613 PRIMER to absorbent substrates. For non-standard substrates, modify them using a suitable method to achieve the required properties. Level substrate irregularities using Cemix 2012 ONE LAYER PLASTER and allow it to dry and harden. The substrate must comply with applicable regulations, standards, or the manufacturer’s material recommendations.
Processing instructions
Apply a thin layer of waterproofing screed to the pre-prepared substrate using a suitable tool, e.g. a brush, and immediately apply the tape. Roll the tape at the expansion joints. Press the tape in and smooth it. Overlap the tape joints by 10-15 cm. When applying the second layer of waterproofing screed, cover the tape with this material. Press in so as not to damage the tape - do not use sharp tools. Temperature resistance: -30 °C to +90 °C Tensile strength: 190% Waterproof: 0.5bar
Consumption
Material consumption min.
0.02
Material consumption max.
-
Material consumption in measuring unit
Pcs/m²
Treatment after application
After application, the direct negative effects of sun, heat, humidity and draughts should be avoided. Protect from frost and rain. Direct heating of the surface is prohibited.
Technical parameters
| Made of material | Based on synthetic rubber with slurry. |
Files
|
|